Position: FAQ > FAQDetail  
Company Policy
Download
Technical Support
FAQ
FAQDetail
Q01 : Disc playback sound is wavering?
Q02 : Disc insertion not possible?
Q03 : Unable to fast forward or backward the disc?
Q04 : Disc playback sound skips due to vibration?
Q05 : Disc playback sound skips without vibration?
Q06 : CD-R/CD-RW playback not possible?
Q07 : Error displays?
Q08 : MP3/WMA is not played back?
Q09 : Unit does not operate?
Q10 : No picture is produced?
Q11 : Playback does not start?
Q12 : Image stops sometimes?
Q01 Disc playback sound is wavering?
Answer:

Moisture condensation in the disc Module. Allow enough time for the condensation to evaporate (about 1 hour). 4

Q02 Disc insertion not possible?
Answer: A disc is already in the DVD player. Eject the disc and remove it.
The disc is being improperly inserted. Make sure the disc is being inserted following the instructions in the CD (MP3/WMA/DVD/Video CD) Player Operation section.
Q03 Unable to fast forward or backward the disc?
Answer: The disc has been damaged. Eject the disc and discard it; using a damaged disc in your unit can cause damage to the mechanism.
Q04 Disc playback sound skips due to vibration?
Answer:

Improper mounting of the unit.
Securely re-mount the unit.

Disc is very dirty.
Clean the disc.

Disc has scratches.
Change the disc.

The pick-up lens is dirty.
Do not use a commercial available lens cleaner disc.
Consult your nearest VALOR dealer.

Q05 Disc playback sound skips without vibration?
Answer: Dirty or scratched disc. Clean the disc; damaged disc should be replaced.
Q06 CD-R/CD-RW playback not possible?
Answer: Close session (finalization) has not been performed. Perform finalization and attempt playback again.
Q07 Error displays?
Answer: Mechanical error Press Eject. After the error indication disappears, insert the disc again. If the above-mentioned solution does not solve the problem, consult your nearest VALOR dealer.
Q08 MP3/WMA is not played back?
Answer: Writing error occurred. The CD format is not compatible. Make sure the CD has been written in a supported format. then rewrite in the format supported by this device.
Q09 Unit does not operate?
Answer:

Monitor power is not turned on.
Turn on the monitor power.

Condensation.
Wait a while (about 1 hour) for the condensation to dry.

Q10 No picture is produced?
Answer:

The unit mode is not switched to the mode you want to see.
Switch to the mode you want to see.


The unit parking brake lead is not connected.
connect the unit parking brake lead and Set the parking brake.
(For details, refer to the unit instructions.)


The unit parking brake is not set.
connect the unit parking brake lead and Set the parking brake.
(For details, refer to the unit instructions.)

Q11 Playback does not start?
Answer:

Disc is loaded upside-down.
Check the disc and load it with the labeled side facing upward.

Disc is dirty.
Clean the disc.

A disc not able to playback with this unit is loaded.
Check If the disc is able to be played back.

Parental lock is set.
Cancel the parental lock or Change the rating level.
Picture is unclear or noisy.


Disc is being fast-forwarded or fast-reversed.
the picture may be slightly disturbed, but this is normal.


Vehicle's battery power is weak.
Check the battery power and wiring.
(The unit may malfunction if the battery power is under 11 volts with a load applied.)


Monitor's fluorescent tube is worn.
Replace the monitor's fluorescent tube.

Q12 Image stops sometimes?
Answer: Disc is scratched. Replaced with a non-scratched disc.